TEMPERATURE SENSOR ALARM SOUNDER SNA-808 SPECIFICATIONS Two-tone electronic sounder. Indoor and outdoor use. IP65 protection. Power voltage 24Vdc 16 mA 0,4W. Operating duty cycle continuous. Operating temperature -25 +80 °C. Dimensions Ø 93 x H 93mm. Packaging 100x100x110mm. Weight 260 g (300 g with packaging). DATA SHEET
SPARK DETECTORS LAC-843 Alarm lamp Lamp with built-in 1Hz flasher. Wall mounting. IP65 protection. Power voltage 24Vdc 3-5mA. DATASHEET
SPARK DETECTORS SNA-808L Alarm sounder beacon Audible visual alarm. Indoor and outdoor use. IP65 protection. Power voltage 24Vdc 16mA 0,4W. DATASHEET
SPARK DETECTORS PAN-701 Alarm panel 24Vdc 36W Allows to monitor two independent detection points. The alarm of the spark detector activates the STOP circuit (it turns on the alarm, stops the fan and closes the duct valve) which is held active until manual reset through the RESET button. The TEST button is used to check…
TEMPERATURE SENSOR TER-616/A – SILO TEMPERATURE SENSOR EXPLOSION-PROOF MODEL DESCRIPTION To be installed inside the silo higher room, where air is clean. It signals an overeating state caused by an ongoing fire or by a smoldering fire. Its NO normally open contact will close when the temperature reaches 88°C (190°F), and it will return back…
TEMPERATURE SENSOR TER-616/TX – TEMPERATURE SENSOR DESCRIPTION also used for ATEX classified areas (all zones) Normally used for temperature control inside the silo or filter installed inside the higher room where air is clean. It is complete of a sleeve which avoids the sensor to be directly in contact with the potentially explosive atmosphere. The…
TEMPERATURE SENSOR TER-616/T – SILO TEMPERATURE SENSOR – WATERTIGHT IP65 DESCRIPTION To be installed inside the silo higher room, where air is clean. It signals an overheating state caused by an ongoing or a smoldering fire. Its NO normally open contact will close when the temperature reaches 88°C (190°F), and it will return back to…
